About Test

About Lactose Intolerance Test

Review the Preparation Guidelines that are enclosed with the test kit that you will receive prior to performing this test!

Recent antibiotic treatment, barium study, colonoscopy, runny diarrhea or similar conditions can affect the test; therefore, DO NOT perform this test within 14 days of any of these conditions or consult a physician prior.

Avoid foods listed in the Preparation Guidelines sheet 12 hours prior to fasting.

• No smoking, including second-hand smoke, for at least 1 hour before or at any time during the test.
• No sleeping or vigorous exercise for at least 1 hour before or at any time during the test.
• With the exception of water, do not eat/drink anything while fasting or during the test! This can cause false-positive readings or cause your test to be unreadable.
• Suggested meals prior to fasting are located in the Preparation Guidelines sheet.
• If you are on any medication or special diets that conflict with these test instructions, itis recommended to speak with your physician before performing this test.

Preparation for the Test

Review the additional enclosed Preparation Guidelines prior to performing this test!

Any recent antibiotic treatment, barium study, colonoscopy, runny diarrhea or similar conditions can affect the test; therefore, DO NOT perform this test within 14 days of any of these conditions.

If you are currently taking laxatives, antacids, Metamucil, Citrucel or similar, please discontinue for at least 24 hours prior and for the duration of the test.

• Avoid foods listed in the Preparation Guidelines sheet 12 hours prior to fasting.
• No smoking, including second-hand smoke, for at least 1 hour before or at any time during the test.
• No sleeping or vigorous exercise for at least 1 hour before or at any time during the test.
• With the exception of water, do not eat/drink anything while fasting or during the test! This can cause false-positive readings or cause your test to be unreadable.
• Suggested meals prior to fasting are located in the Preparation Guidelines sheet.
• If you are on any medication or special diets that conflict with these test instructions, it is recommended to speak with your physician before performing this test.

Prepare Test Solution - DO NOT DRINK YET!!!

If you are unable to determine your dosage amount, consult your physician.

1. Mix the packet of the enclosed substrate into 8 oz. (250 ml) of water.
2. Find your weight in the Mixing Chart below.
3. Remove required amount of solution based on your weight.
4. Add required amount of water to the remaining solution. Set drink aside.

Performing the Test (Collection Steps)

Collect your baseline sample following steps 1-4.

	Hold the EasySampler device in one hand and a collection tube in the other hand. You will only exhale once per each sample collection. Take a normal (not deep) breath in; close your mouth around the mouthpiece then blow out normally.
	Exhale once per each sample collection. As you exhale the bag fills with air. Keep it inflated. (There is a small hole in the bag, this is intentional). During your exhalation, insert the test tube into the needle holder completely so the stopper on the tube is punctured.
	Remove the test tube after 1-2 seconds. Keep the bag inflated until after the test tube is removed from the test tube holder.
	Complete the tube label provided. Make certain you label the Sample # correctly or your results will be inconclusive.

After collecting your baseline sample, drink the test solution you prepared.

After drinking the solution, collect one sample every 30 minutes.

Collect all samples following the Sample Chart and Collection Steps 1-4.

Put collection test tubes in the bubble bag(s). Place the bubble bag(s), any paperwork, and the EasySampler device back in the cardboard container, and return to the laboratory for analysis immediately.

Return the kit immediately for analysis.

Your breath sample is only stable for 14 days after collection.